Barrel Thread Converter / Adapter M14x1 LH to 9/16"-24 Male, Steel, Black

(1 review) Write a Review
4.00 Ounces
Bulk Pricing:
Buy in bulk and save
  • Barrel ,Thread Converter / Adapter M14x1 LH to 9/16"-24 Male, TUFFORCE Item # 9-141L 
  • 33 mm /1.4" Length
  • Diameter of Internal hole : 10.2mm / 0.37"
  • Steel , BlacK
This converter allow connect with an Oil Filter adapters of TUFFORCE, 5/8" - 24 To 13 /16"-16 Male, Item # MB-13/524, 
which work as a  Solvent Trap or combine as a Tufforce two piece Muzzle Brake.
*Total 3 sizes Barrel thread to 9/16"-24 Male Converters are available under TUFFORCE Brand as list below.
       -  #9-128, Thread Converter / Adapter 1/2" - 28 to 9/16"-24 Male 
       -  #9-524, Thread Converter / Adapter 5/8" - 24 to 9/16"-24 Male 
       -  #9-141L, Thread Converter / Adapter M14x1 LH to 9/16"-24 Male 


1 Review Hide Reviews Show Reviews

  • 4
    Solid, clean threads, just not deep enough for the full barrel threading.

    Posted by Travis Marshall on Sep 21st 2020

    I used this to adapt my AK threads to the threads on my 30cal muzzle device, and my only complaint is that the female threads are not deep enough to fully seat on the AK threaded barrel. There is about a 1/16" gap between the end if the threads and the end of this adapter. It is definitely useable after adding a key to this part for the barrel pin on the AK (which I knew I had to do before buying this part so this is not a complaint for that piece) but it would look and feel a lot better if the female M14X1 threads were 1/16" deeper. Other than that, love it and from a few steps back, the gap doesn't affect the aesthetic much at all.