Barrel Thread Converter / Adapter M14x1 LH to 9/16"-24 Male, Steel, Black

Was: $29.99
Now: $27.32
(2 reviews) Write a Review
Weight:
4.00 Ounces
Bulk Pricing:
Buy in bulk and save

Bulk discount rates

Below are the available bulk discount rates for each individual item when you purchase a certain amount

  • Buy 5 - 10 and get 15% off
  • Buy 11 - 20 and get 25% off
Barrel Thread Converter / Adapter M14x1 LH to 9/16"-24 Male, Steel, Black
  • Barrel ,Thread Converter / Adapter M14x1 LH to 9/16"-24 Male, TUFFORCE Item # 9-141L 
  • 33 mm /1.4" Length
  • Diameter of Internal hole : 10.6 mm / 0.42"
  • Steel , BlacK
NOTE:
This converter allow connect with an Oil Filter adapters of TUFFORCE, 5/8" - 24 To 13 /16"-16 Male, Item # MB-13/524, 
which work as a  Solvent Trap or combine as a Tufforce two piece Muzzle Brake.
 
*Total 3 sizes Barrel thread to 9/16"-24 Male Converters are available under TUFFORCE Brand as list below.
       -  #9-128, Thread Converter / Adapter 1/2" - 28 to 9/16"-24 Male 
       -  #9-524, Thread Converter / Adapter 5/8" - 24 to 9/16"-24 Male 
       -  #9-141L, Thread Converter / Adapter M14x1 LH to 9/16"-24 Male 

 

2 Reviews Hide Reviews Show Reviews

  • 5
    Thread adapter

    Posted by Timothy Yates on Feb 8th 2021

    I highly recommend this thread adapter. I had one before and it wasn't even close to being as well made as this one. The flats come in handy, I know they don't look good but this is an AK we are talking about here. Mine bottomed out and tightened up on the tip of the barrel, not the front sight as a typical AK device would. This is most important if you plan on suppressing.

  • 4
    Solid, clean threads, just not deep enough for the full barrel threading.

    Posted by Travis Marshall on Sep 21st 2020

    I used this to adapt my AK threads to the threads on my 30cal muzzle device, and my only complaint is that the female threads are not deep enough to fully seat on the AK threaded barrel. There is about a 1/16" gap between the end if the threads and the end of this adapter. It is definitely useable after adding a key to this part for the barrel pin on the AK (which I knew I had to do before buying this part so this is not a complaint for that piece) but it would look and feel a lot better if the female M14X1 threads were 1/16" deeper. Other than that, love it and from a few steps back, the gap doesn't affect the aesthetic much at all.